Expert Answers about Pontiac Grand Am

• Curt Wiring Harness Recommendation for a 1999 Pontiac Grand Am
• The Curt Custom Fit Vehicle Wiring # C56175 that you referenced is the correct wiring kit for your 1999 Pontiac Grand Am. In order to install this you will basically just need a circuit tester like our part # PTW2993 to determine which wire is what on the tail light harness of your vehicle. Basically you will just wire it up like the box recommends. For the green wire of the converter box you would run a wire to the right turn circuit, the red wire to the stop light circuit, the yellow...
  view full answer...


• Where Does a Curt Trailer Hitch Install on a 1999 Pontiac Grand Am
• The short answer is both. There are attachment points on the bottom of the frame and on the bumper mounts. I have included a link to the installation instructions for you to view. If you plan on doing some towing, the hitch comes with the correct ball mount, pin, and clip. For a 1-7/8 inch ball, you can use # 19256. For a 2 inch ball use # 19258. For trailer wiring use # 119178KIT. I have linked the wiring instructions as well.
  view full answer...


• Hole Enlargement Needed to Install Draw-Tite Hitch 36288 on 2004 Pontiac Grand Am
• Draw-Tite Trailer Hitch Receiver # 36288 for your 2004 Pontiac Grand Am will require you to enlarge the two existing holes using a 1/2-inch drill bit. This is noted in step 2 of the linked instructions. I also linked a video showing this hitch installed on a 2002 Grand Am.
  view full answer...


• Is Exhaust Removal Required to Install Draw-Tite Trailer Hitch # 36288
• You would not need to remove or lower the vehicle exhaust to install hitch # 36288. This hitch is a fit for the 1999 through 2004 Oldsmobile Alero, and also the 1999 through 2005 Pontiac Grand Am, including GT models. You can view the instructions for the # 36288 hitch, as well as a video showing a typical installation.
  view full answer...


• Installation of Timbren Suspension Springs TGMRLUM on a 1995 Pontiac Grand Prix
• The installation of rear suspension enhancement kit # TGMRLUM is very straightforward on your 1995 Pontiac Grand Prix. You would start by lifting up the vehicle so that the axle is hanging freely, and you would locate the existing bump stop assembly. Remove the bump stop, but keep the fasteners, as these are used for the suspension kit installation. Once you have cleared the area, you would install the rubber spring and bracket in the same location, using your OEM fasteners. Finish...
  view full answer...